Page 1 of 1

Cannot type dimensions for help lines

Posted: Tue May 15, 2018 2:44 pm
by JCharron
Installed version 8 to test out working with imported image. However, I cannot enter numbers for my help lines now. They show the #, and a unlocked lock, but nothing can be entered. Could this be addressed asap please? I'm not sure how to roll back to a previous Dialux version.
Thank you,

Re: Cannot type dimensions for help lines

Posted: Wed May 16, 2018 8:11 am
by Csuleiman
Dear JCharron,

In the new evo version 8.0 you can enter those values directly in the CAD view by clicking on the tab key of your keyboard. Just insert a reference line and then click on tab to enter the length. With the next tab you can enter the angle.

Unbenannt.JPG
Unbenannt.JPG (69.5 KiB) Viewed 287 times

Best regards,
DIAL Support Team