Page 1 of 1

Lightbox simulation

Posted: Thu Dec 31, 2015 7:57 am
by Justinas
Hello I am workink in LED company, and I need to simulate lightbox in dialux. I have module ies/ldt files. How can I simulate it? I need get result outside plexiglass (not inside). I used smaal room and take glass with transparency and reflection is it right?

Re: Lightbox simulation

Posted: Mon Jan 04, 2016 2:39 pm
by T.Magenheimer
Dear Justinas,

You should construct such a lightbox with the help of some extrusion volumes. With whom you can construct the outer casing of the lightbox.
Than you give the rear wall the texture of the commercial and the front wall a glass texture.

In this lightbox you can insert your LED luminaires and your project is finished.

You will get a mail from me with an attached project file where I rudimentary construct a lightbox for you.


Kind regards,
Your DIAL Support team