Page 1 of 1

percentage area with desired lux level range

Posted: Thu Nov 23, 2017 1:54 pm
by Ganesh
Hi,
1. How to get output based on percentage area with lux level range while performing daylight simulation?

I need % area of work-plane within 200-950 lux level (natural daylight).

2. Can we perform LEED v4 daylight calculation in DiaLux evo?

Thanks

Re: percentage area with desired lux level range

Posted: Mon Nov 27, 2017 12:51 pm
by T.Magenheimer
Dear Ganesh,

We didn't implement LEED in our evo software and I do not know the LEED requirements in detail. You can only try to achieve this by using calculation surfaces and their positioning options and calculation parameters.

Can you please explain us your first question (e.g. with the help of some screenshots)?


Kind regards,
Your DIAL Support Team

Re: percentage area with desired lux level range

Posted: Tue Nov 28, 2017 4:12 am
by Ganesh
Thanks T.Magenheimer for your response.

Please find attached snapshot of apartment house in which daylight simulation has been performed for bedroom. I want to know how much % of floor area of bedroom is receiving the lux level in between 110 to 1100.

Regards

Re: percentage area with desired lux level range

Posted: Thu Nov 30, 2017 1:27 pm
by T.Magenheimer
Dear Ganesh,

Unfortunately this is not possible in our evo software.


Kind regards,
Your DIAL Support Team