Page 1 of 1

Editing Luminaire housing on import

Posted: Thu Jan 04, 2018 8:05 pm
by RJH
I'm a new user. I made a mistake when importing an .ies file and caused the height of the luminaire's housing to read 18 ft. Once its imported it doesn't seem to allow me to edit that value again. How can I change that value once it's in the database? I've tried deleting the file and reimporting it but to no avail.

Re: Editing Luminaire housing on import

Posted: Fri Jan 05, 2018 8:16 am
by Csuleiman
Dear RJH,

You just have to delete this IES file from the luminaires recent list as shown in the screenshot below. Afterwards you can insert the IES once again and adapt the geometry to your needs.

Image1.jpg
Image1.jpg (107.77 KiB) Viewed 1612 times

Best regards,
DIAL Support Team