DIALux evo board

Hi,

I need to draw a roof as below, however none of the preset roofs match this.
Any suggestions on how I can create it in another way?
Thanks.

Hey,

So what I would do is next to my dwg that I would import to draw my building i would also include this sketch below. I would draw it out with an extrusion body and then rotate it to have it in the proper orientation!

Hope this makes sense

Hi julianateclighting,

Round roofs are not available in evo, but the following link leads you to an article from our knowledge base, which may be of help in creating such a roof:

https://evo.support-en.dial.de/support/ ... round-roof

Besides this, we would like to recommend you to have a look at our video tutorials. Here is a link to our YouTube channel where you find several tutorials about how to use our evo software: https://www.youtube.com/user/TheDIALux

This is a link to the YouTube channel where you can find a video explaining how to create a complicated roof in evo:
https://www.youtube.com/watch?v=5pIBNNfHzpU

Best regards,
DIAL Support Team