Page 1 of 1

How Can I Specify a Streetlight Pole Offset?

Posted: Fri Jun 21, 2019 12:33 am
by bradharvey
Hi,

Inexperienced user here.... :roll:

Is there any way to create a standard pole outreach/offset for an individually placed luminaire?

For example, I am modelling in streetlight pole locations, but the actual luminaire is on a 3m outreach arm from the pole.

I can't see anything in the luminaire settings which allows me to do this.

Thanks,
Brad

Re: How Can I Specify a Streetlight Pole Offset?

Posted: Thu Jun 27, 2019 7:58 am
by Csuleiman
Hi Brad,

Have you already checked the light centre height as it is marked in the screenshot below?

Screenshot.JPG
Screenshot.JPG (58.72 KiB) Viewed 1616 times

Best regards,
DIAL Support Team