Page 1 of 1

Glare ratio calculation

Posted: Mon May 14, 2018 2:42 pm
by JohnLanghout
Hello,

I'm calculating for a soccer field. The GR has to be below 50. To be sure I meet the requirements, I now put over the soccer field GR observers in a grid of 10 by 10 meters. When done so I have to check the output and check every line for the result.
Is there an other way to do this? For instance a measurement layer which gives the results just like the average with ISO lines but than with the ISO lines for the GR values?

Regards,

John

Re: Glare ratio calculation

Posted: Wed May 16, 2018 8:07 am
by Csuleiman
Dear John,

If you would like to get a grid of GR observers, then there is no other possibility as to insert several GR observer points to the required positions.

Best regards,
DIAL Support Team