Create a circular positioning with 1 luminaire

How to construct ...
Locked
PierreConan
Posts: 1
Joined: Wed May 10, 2017 10:19 am

Create a circular positioning with 1 luminaire

Post by PierreConan » Wed May 10, 2017 12:03 pm

Hello every one,

I don't know if I'm in the good topic but I try with this one. I'm mostly using Dialux 4 for street lighting on a DWG draw. I'm trying to use Dialux Evo but there's a lack when I want to put a circular positioning. In Dialux 4 it was possible to make a circular positioning with just 1 luminaire. It helped me because I was able to modifiy quickly the length of my luminaire's stick. In Dialux Evo, the minimum value with a circular positioning is 2 luminaires. And it didn't helped at all ;)
Do you have a solution for my problem ?

Thanks in advance,

Pierre CONAN

Csuleiman
Posts: 1996
Joined: Wed Mar 07, 2012 3:07 pm

Re: Create a circular positioning with 1 luminaire

Post by Csuleiman » Thu May 11, 2017 6:03 am

Dear PierreConan,

We have specified this behavior in evo in another way as it is in DIALux 4. The only workflow to get a circular with only one luminaire is to delete the other one after you've set the circular arrangement.

Best regards,
DIAL Support Team

Locked

Who is online

Users browsing this forum: No registered users and 5 guests