Page 1 of 1

Rotate tool ON after Insert

Posted: Wed May 16, 2018 2:57 pm
by knjaz
Have a proposal to fasten the workflow.
After inserting copied luminaire with Ctrl+M (paste in place) in DL Evo 8 at top view, we currently have Move tool activated. Instead of that, it'd be great to have Rotate tool automatically activated as it was in DL4 (after Ctrl-H in floor plan Top view). If we have chosen the place we want to insert, than all we need is to rotate it properly.
001.jpg
001.jpg (252.25 KiB) Viewed 48 times

Re: Rotate tool ON after Insert

Posted: Wed May 16, 2018 3:01 pm
by knjaz
Of course, it's OK to have Move tool after ordinary paste with Ctrl+V.

Re: Rotate tool ON after Insert

Posted: Wed May 16, 2018 8:42 pm
by T.Magenheimer
Dear knjaz,

Thank you very much for your feedback. We will put this point on our improvement list.


Best regards,
DIAL Support Team