Rotate tool ON after Insert

feel free to add wishes and suggestions
Locked
knjaz
Posts: 26
Joined: Thu Nov 28, 2013 3:31 pm

Rotate tool ON after Insert

Post by knjaz » Wed May 16, 2018 2:57 pm

Have a proposal to fasten the workflow.
After inserting copied luminaire with Ctrl+M (paste in place) in DL Evo 8 at top view, we currently have Move tool activated. Instead of that, it'd be great to have Rotate tool automatically activated as it was in DL4 (after Ctrl-H in floor plan Top view). If we have chosen the place we want to insert, than all we need is to rotate it properly.
001.jpg
001.jpg (252.25 KiB) Viewed 352 times
Lux ex machina / UA

knjaz
Posts: 26
Joined: Thu Nov 28, 2013 3:31 pm

Re: Rotate tool ON after Insert

Post by knjaz » Wed May 16, 2018 3:01 pm

Of course, it's OK to have Move tool after ordinary paste with Ctrl+V.
Lux ex machina / UA

T.Magenheimer
Posts: 1195
Joined: Thu Jul 26, 2012 10:16 am

Re: Rotate tool ON after Insert

Post by T.Magenheimer » Wed May 16, 2018 8:42 pm

Dear knjaz,

Thank you very much for your feedback. We will put this point on our improvement list.


Best regards,
DIAL Support Team

Locked

Who is online

Users browsing this forum: No registered users and 0 guests