Search found 18 matches

by Bushair
Mon Feb 11, 2019 6:01 am
Forum: Using DIALux 4
Topic: Making Emergency fixture run on normal scenario
Replies: 2
Views: 3061

Making Emergency fixture run on normal scenario

Hello, I intend to use an Emergency Fixture called Protecta III Ex-rated Fluorescent fixture - PRGE/236/BI/EM to conduct lighting calculations for my indoor substation area. I know that when this fixture functions on NORMAL mode (meaning supplied from plant mains power supply), the lumen output of t...
by Bushair
Tue Feb 05, 2019 11:10 am
Forum: Using DIALux 4
Topic: Problem with Light loss factors
Replies: 2
Views: 3478

Re: Problem with Light loss factors

Thank you.
by Bushair
Fri Feb 01, 2019 9:40 am
Forum: Using DIALux 4
Topic: Problem with Light loss factors
Replies: 2
Views: 3478

Problem with Light loss factors

Hello, I enter the light loss factor in the Settings tab - General Options. However, the value entered there is not the same as the value that the software uses when it performs the lighting calculation. For instance, I enter a light loss factor of 0.70 in the General Options page. However, the ligh...
by Bushair
Thu Jan 31, 2019 1:57 pm
Forum: Using DIALux 4
Topic: Different lux levels depicted in the calculation sheets
Replies: 2
Views: 2954

Different lux levels depicted in the calculation sheets

Hi, When I perform lighting calculations using Dialux 4.13 and generate the calculation report, I see two different sets of results for the calculated lux levels depicted in the calculation plan from the calculated lux levels in the output reports that gets generated. There isn't coherence between t...
by Bushair
Thu Jan 31, 2019 1:42 pm
Forum: Problems
Topic: How do we make spacing in calculation grid?
Replies: 2
Views: 2488

Re: How do we make spacing in calculation grid?

Thank you for the clear explanatory answer.
by Bushair
Thu Jan 31, 2019 11:09 am
Forum: Problems
Topic: How do we make spacing in calculation grid?
Replies: 2
Views: 2488

How do we make spacing in calculation grid?

Hi, After we perform lighting calculations and generate a report, the page Calculation Grid 2 illustrates the lux levels achieved in the form of grid points on the selected area. How do we make spacing between the grid points larger? I don't want Dialux to calculate lux levels at each point so close...