Dimensions calculation object not in report/documentation

[AntoonB]

Hello,

When in the report of a calculation I would like to show the dimensions of
the calculated area / object I have used in the calc.
in the tab "Documentation", menu "Configure Page (F2)"
I just check on : "Dimensioning" but nothing is showed at
the calculation object page.

Is there another possiblity to show the dimensions of the calculation object
in the Documentation / report ?

BR,

AntoonB

[Csuleiman]

Hello AntoonB,

The checkbox for "Dimensioning" in the documentation refers to the manually inserted dimensioning in the "Help lines and labeling" tool - as shown in the screenshot. You can enable/disable this dimensioning on the corresponding output pages.
This is also the only way to dimension calculation surfaces, rooms, etc. Automatic dimensioning is not yet implemented in evo.

Screenshot.JPG (152.1 KiB) Viewed 468 times

Best regards,
DIAL Support Team