Page 1 of 1

Outdoor working area Surrounding area

Posted: Fri Sep 20, 2019 12:46 pm
by Christophe
Dear,
A per EN 12464-2 table 1 outdoor surrounding area must reach value.
However it is not possible to create a work area in outdoor spaces ??
How can I proceed because with the tool "draw rectangular caluclation object" it is nor working.
Thanks in advance
Christophe

Re: Outdoor working area Surrounding area

Posted: Mon Sep 23, 2019 11:26 am
by T.Magenheimer
Dear Christophe,

This is not possible in our DIALux evo software. You can only use normal calculation surfaces in the outdoor area.


Best regards,
Your DIAL Support Team

Re: Outdoor working area Surrounding area

Posted: Wed Sep 25, 2019 11:43 am
by Christophe
Hi,
Thanks for your prompt reply.
Do you foresee to integrate it in next revision of dialux?
Christophe

Re: Outdoor working area Surrounding area

Posted: Wed Sep 25, 2019 11:52 am
by T.Magenheimer
Dear Christophe,

This will not be implemented in our next evo version. But it is on our improvement list.


Best regards,
Your DIAL Support Team