LDT editor, No change after adjusting luminous area and/or lumen output

crashes, error report
Post Reply
yzmmywx
Posts: 1
Joined: Tue Jun 21, 2022 3:12 pm

LDT editor, No change after adjusting luminous area and/or lumen output

Post by yzmmywx » Tue Jun 21, 2022 3:29 pm

I'm using LDT Editor V1.4.2.0

When I open a LDT file, get the light distribution and UGR result.

But after I adjusted the luminous area and/or lumen output, nothing changed about UGR result.

Could some tell me what I did wrong?

Thanks.
Attachments
problem.JPG
problem.JPG (66.92 KiB) Viewed 121 times

F.Krewett
Posts: 75
Joined: Mon Jul 06, 2015 2:16 pm

Re: LDT editor, No change after adjusting luminous area and/or lumen output

Post by F.Krewett » Wed Jun 29, 2022 11:56 am

The changes are not applied on the fly for the UGR table or polar diagram. The diagrams are generated by loading a file and will then remain unchanged. If you will save the file and load it once again you can see the new diagrams.

Regards
Fabian

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest